Hermes Quick Setup Guide

Please search and download the free Amaryllo APP to get started.

1. Connect the  USB cable to a power outlet.
2. The blue LED light will illuminate when the device is powered on.
3. Wait for it to start flashing before beginning installation. 
4. After power-on, it will take 25 seconds to start calibration cycle. 

1. Please make sure that your smart phone is connected to the same Wi-Fi SSID network.

2. Select Hermes in the APP then follow the instructions shown.

★ Please refer to the Tips & How-Tos page (amaryllo.us/tips-and-how-tos) for more info on how to share the viewer or administrator access to other smart phone device.

1. Switch on your phone's Wi-Fi. Connect your phone to the same router as the camera.
2. Enter the password of your Wi-Fi router.
3. Your device will automatically generate a QR code.
4. Place the camera 4” ~ 11.8” (10~30 cm) in front of the QR code or 7.8” ~11.8” (20~30 cm) if using a tablet.
5. Please wait for a beep to confirm reception. After you hear a beep, you can put the phone down.

★ Make sure your camera and the phone/tablet are parallel to each other.

Note: The camera is designed for easy DIY installation but if you need local assistance, please visit www.amaryllo.us to locate a professional installer near you.

★ Please be sure your device is running on the latest firmware.

Blue LED

Stable: Camera is powered on.

Flashing: 1.Camera is in installation mode.

                 2.After installation success, blue LED light flashes when it is being viewed

by user.

Green LED

Stable: Camera is connected to Wi-Fi.

Flashing: Camera is attempting to connect to a Wi-Fi AP router.

• First, make sure the device is powered on and the calibration is completed.
• There is a small RESET hole. Press and hold for about 3 - 5 seconds until you hear a beep. All settings previously stored in the device will be erased, and it will be restored to the factory default.
• After 25 seconds, the device will start a calibration mode by rotating itself. (for remote models)

1. Make sure that an electric outlet is within 2 meters. Choose a location that will offer you the best viewing angle.
2. Use a pencil to mark the hole locations. Make sure the holes are slightly smaller than anchors.
3. Insert anchors into wall and secure holder to wall with screws. 
4. Insert USB power plug through holder opening from the rear.
5. Plug the device into USB adapter and adjust until proper angle is achieved.

★ Need help? Visit https://www.amaryllo.us/tips-and-how-tos or drop us an email with photo or video and description of the problem to support.ai@amaryllo.us

★ Warranty is voided if camera is dissembled.